| The rear leaf springs and axle were replaced with fabricated brass parts soldered together. The shocks are machined aluminum and brass. |
|
|
| This is the left side before attaching the traction bar mount to the spring assembly. All brass, including the axle tube. |
|
|
| This is the basic assembly of the right side leaf spring with the traction bar mount installed to the axle tube |
|
|
|
| Another angle. |
|
|
| I have started to paint the chassis and exhaust… |
|
|
| Different view... |
|
|
|
| The rear suspension is going in. Mounting hardware is machined aluminum. The left side traction bar is partially installed at this point. |
|
|
| The pumpkin was cut from the Camaro kit’s axle assembly and textured and weathered. |
|
|
| The scratchbuilt (aluminum) Corvette front monoleaf suspension parts are getting installed too… |
|
|
|
| Additional image. |
|
|
|